Swing Louvre Function; How To Read The Swing Monitor - Mitsubishi Electric MJ-E26SX-A1 Instruction Manual

Swing louvre function

The louvre can be made to swing. Select from the 5 possible settings to suit the purpose.
¡Starts swing
operation.
¡The swing monitor
is displayed.
The swing operation
stops when the power
cord is unplugged.
∞ The level of noise emitted from
the unit varies according to the
angle of the air-flow.
∞ The louvre may stop up to a
maximum of 8 seconds to correct
its position, after which it will start
moving again.
∞ Do not place your fingers or other
objects in the louvre to change
the swing angle. Set the swing
direction according to the
procedures in the section
"Changing the swing direction".
12

(how to read the Swing monitor)

Press
With each press
of the button
Viewing the Swing Monitor
This indicates the range of louvre swing.
(The louvre and monitor do not move in
synchronization.)
¡Stop swing operation
¡ The louvre stops in a vertical
¡ The swing monitor turns off.
To change the louvre to a desired
angle, wait until the louvre stops,
then adjust by hand.
¡WIDE
To cover the entire room.
¡UPWARD
For drying clothes, etc.
Swing speed is automatically
controlled to send air to all corners
of the room.
front
¡Low Air Outlet
Convenient for drying carpets or
beds.
When using the low air outlet, do
not close the louvre, as it needs to
open slightly to make directional
adjustments.
¡REAR
For directing air into a closet.
Depending on the angle of the
louvre, some air may blow out of
the low air outlet.
position.
60°
Swings slowly to
30°
send air further
(no swing function)