Table of Contents
Advertisement
Using Louvre
The louvre can be made to swing. Select from the 4 possible settings to suit the purpose.
Automatic louvre starts
The monitor displays louvre direction
Remove the plug from the power socket and
connect again, automatic louvre stops.
Displays louvre swing range
(The louvre and monitor do not move in
synchronization.)
Objective
To stop the
louvre at the
desired angle
To dehumidify
closets
To dry the
laundry
To cover the
entire room
The level of noise emitted from the unit varies depending on the air-blowing direction.
To locate the position, the air outlet may stop up to 8 seconds and then start operating again.
If the louvre is touched by hand or object, the louvre angle will change, so readjust the louvre by pressing the louvre switch.
If air is blown directly onto a wall, the wall may become dirty because of dust in the air.
This dehumidifier memorizes the swing direction but not the desired angle at which the louvre was stopped. The next time
you start it, it returns to the default setting (upward).
16
Blip
Press
Recommended
swing mode
Louvre stopped
Rear
Upward
Wide
Each time
the switch
is pressed,
the swing
direction
changes.
Explanation of swing
Louvre stops in a vertical position, and louvre display
screen will disappear.
To change louvre to a desired angle, adjust the louvre
angle by hand.
The louvre swings to send air to the back of the unit.
The louvre swing speed is automatically controlled so that
there is even distribution of air supply to the laundry.
40°
20°
The louvre moves slowly through the last
20°of the swing, as it takes shorter time to
traverse the upward arc than the rear arc
when louvre moves at a constant speed.
The louvre swings from the upward position to the rear
position to send air to all corners of the room.
Louvre
stopped
Blip
Blip
Rear
Blip
Upward
Blip
Blip
Wide
Advertisement
Table of Contents
