Swing Louvre Function - Mitsubishi Electric MJ-E16VX-S1 Instruction Manual

Swing louvre function

The louvre can be made to swing. Select from the 4 possible settings to suit the purpose.
¡ Starts swing operation.
¡ The swing monitor is displayed.
The swing operation stops when the power
cord is unplugged.
This indicates the range of louvre swing.
(The louvre and monitor do not move in
synchronization.)
Objective
To stop the
louvre at the
desired angle
To cover the
entire room
For drying
clothes, etc.
For directing
air into a
closet
∞ The level of noise emitted from the unit varies according to the angle of the air-flow.
∞ The louvre may stop up to a maximum of 8 seconds to correct its position, after which it will start moving
again.
∞ If the louvre is knocked out of the desired angle, readjust by following the above steps.
Stop the louvre in the vertical position when using the unit against a wall. Blowing air at the wall may cause
staining.
16
Press
Recommended swing setting
¡Stop swing
operation
¡WIDE
¡UPWARD
¡REAR
(how to read the swing monitor)
With each press
of the button
Explanations of the swing modes
¡ The louvre stops in a vertical position.
¡ The swing monitor turns off.
To change the louvre to a desired angle, wait until
the louvre stops, then adjust by hand.
The louvre swings from the UPWARD position
through to the REAR position.
Swing speed is automatically controlled to send air
at washing from all angles.
60°
The louvre moves slowly through
30°
the last 30° of the swing, as the
time taken to traverse the rear arc
is shorter than that for the upward
arc when moving at a constant
speed.
Stop swing
operation
WIDE
UPWARD
REAR