Table of Contents
Advertisement
Genesis Digital™ HDMI Matrix Switches
5.3.2 Load factory defaults
To load factory defaults from serial interface use following commands.
FD<cr>
Command:
Applying settings to Matrix please wait.
Response:
Wait until you see following welcome message on terminal screen.
"Welcome to Hall Research HSM matrix."
."
(Note: After loading factory defaults Matrix will reset to default values as mentioned in
section 5.2.4 Factory Default Settings)
6. Telnet Interface
HSM Telnet interface is IP based command line interface to control and monitor
matrix. Only one (1) client is allowed to connect at a time through this interface and on
every new connection, old connection will be closed. Telnet connection timeout is set
to infinity or until user closes connection. Telnet authentication depends on
authentication status of web interface. If authentication is enabled, password will be
same as what used for web interface. User can also disable telnet interface from web
interface.
31
Advertisement
Table of Contents
