Hall Research Technologies HSM-I-08-08 User Manual page 9

Using quality HDMI cables connect the inputs to video sources.

If the sources are DVI (PC) then you will need either a DVI to HDMI adapter,

or preferably, a DVI to HDMI Cable
For a professional installation, we recommend using locking HDMI cables.

The Matrix Switch has a tapped hole above each HDMI connector and the
locking cables available from Hall Research come with screws and stand-
offs for securing the cables in place so they don't accidentally get unplugged
Plug the power supply to the unit.

unit
If the matrix needs to be controlled via RS-232, plug the controller (or PC) to

the DB9 Female port on the rear of the matrix. Connection to PC's DB9 Male
is made using a straight through DB9 Male-to-Female cable (as shown
below). This port operates at a baud rate of 115,200.
Table 1 – RS-232 Control Port Pinout
To control the matrix via the IP port, just connect an RJ45 cable to your

Local Area Network (LAN). This unit features a user friendly and powerful
Genesis Digital™ HDMI Matrix Switches
Figure 3 –
Model C-HDMI-DVI-xM
Figure 4 –
Model C-HDMI-L-x
(x = 1.5, 3, 6, 10, 15, 25, 35 or 50 ft)
Next, connect the HDMI outputs to the displays.

Use only the supply that came with the
(x = 2, 3 or 5 meters)
7