Current Status; Error Commands - Hall Research Technologies HSM-I-08-08 User Manual

HSM-I-08-08
This command is useful for several purposes. For example, if you do not have HDCP
compliant displays on all outputs and you try to send an input with HDCP to an output
display that is not HDCP compliant, you will not get an image. This command enables
you to check the status of each input and only route content that can be displayed to
those outputs. In addition, since this command detects presence of video on inputs,
you can use it to check status of inputs and reroute outputs if there is no video on the
input currently routed.

4.14 Current Status

Command:
Response:

4.15 Error Commands

ERR1 – Invalid command sent by the user (Any commands other than the above list)
ERR2 – The user sends a command to the HSM matrix while the power is off
ERR3 – The front panel is in use. The front panel times out after 8 seconds if no
activity is detected from the user.
HSM matrices equipped with IP Port have special Serial
Commands to change IP address parameters. Please refer section
5.3 IP Specific Serial Commands for further info.
18
ST<cr> stands for Status Query
PW1<cr>
CV1,m<cr>
CV2,m<cr>
CV3,m<cr>
CV4,m<cr>
CV5,m<cr>
CV6,m<cr>
CV7,m<cr>
CV8,m<cr>
CA1,m<cr>
CA2,m<cr>
CA3,m<cr>
CA4,m<cr>
CA5,m<cr>
CA6,m<cr>
CA7,m<cr>
CA8,m<cr>
Notice about Additional Commands
DH1,x<cr>
DH2,x<cr>
DH3,x<cr>
DH4,x<cr>
DH5,x<cr>
DH6,x<cr>
DH7,x<cr>
DH8,x<cr>
AH1,x<cr>
AH2,x<cr>
AH3,x<cr>
AH4,x<cr>
AH5,x<cr>
AH6,x<cr>
AH7,x<cr>
AH8,x<cr>
MCx<cr>
OSx<cr>
OTx<cr>
OBx<cr>
NI1,[yyy]<cr>
NI2,[yyy]<cr>
NI3,[yyy]<cr>
NI4,[yyy]<cr>
NI5,[yyy]<cr>
NI6,[yyy]<cr>
NI7,[yyy]<cr>
NI8,[yyy]<cr>