Lamp Optimization - Elation PLATINUM SPOT 5R PRO User Manual

7. Be sure to reset the lamp run time in the system menu to avoid any possibly of the
lamp protection circuitry from accidently shutting off the lamp during normal
operation.
8. If the lamp protection circuitry has already been initiated and the lamp run time is not
reset the "Replace the Lamp" warning will continue to flash in the display and the
fixture will eventually shut down. To reset the lamp running time follow the
procedures below;
A. Activate the menu by pressing the "Mode/Esc" button and toggle to
"Information"
B. Once at "Information" tap the "Enter" button anduse the "Up" or "Down"
buttons to toggle to "Time Information"
C. Once at "Time Information" us either the "Up" or "Down" buttons to toggle to
"L-Timer Password" and tap the "Enter" button. Then use the "Up" or "Down"
buttons to enter the reset pass code, "038" and tap the "Enter" button once
again. The display will automatically revert to "L-Timer Password," next
toggle down to "Clear Lamp Time"
D. Once at "Clear Lamp Time" tap the enter button and select "ON." The lamp
timer has now been reset, use the "MODE/ESC" button to exit the menu and
return to the home screen.

Lamp Optimization

Unlike traditional discharge lamps the Platinum 5R lamp does not require optimization. The
lamp orientation and optimization procedure has been preset during the manufacturing
process of the lamp.
Please remember that a MSD Platinum 5R lamp is not a hot-restrike lamp therefore, you
must wait approximately 15 minutes before you can attempt to strike the lamp once it has
been turned off.
©Elation Professional, Los Angeles, Ca 15 www.ElationLighting.com
Platinum Spot 5R Pro™