Use Active Configuration Standalone - Fujitsu SK-91F467D-208PFV User Manual

Start Softune Workbench Monitor Debugger via the "Debug" Command
Figure 5-6: Start Softune Workbench Monitor Debugger
11. After the project is built and debugged successfully switch to the active configuration
STANDALONE

5.2.3 Use Active configuration STANDALONE

12. With this selection the project is linked to work in internal flash memory. Check that
the macro "SWBMonDeb" is switched off (default) in the Assembler options
(<Project>, <Setup Project>, <Assembler>, category <Define Macro>.
This configuration will not work with the Softune Workbench Monitor Debugger. In
this configuration the code is linked to work in internal Flash memory, only.
13. Use "Make", or "Build" to compile and link the project for internal Flash memory. The
generated output files can be found in the sub-folder STANDALONE of the project
folder. The *.mhx file (Motorola S-Record) is located in the ABS sub-folder.
14. Program the generated *.mhx file (Motorola S-Record) with the Flash programming
utility into the internal Flash. See Chapter 6.1 "Programming the internal Flash
Memory" for more details.
© Fujitsu Microelectronics Europe GmbH
SK-91F467D-208PFV V1.1
Getting Started
Note:
Always check the memory map of the linker settings and ensure
that this memory map is suitable for the application and target
system in use. Additionally the *.mp1 file should be checked to
ensure correct settings.
- 41 - FMEMCU-UG-910014-10