Table of Contents
Advertisement
2. Instruct Procomm to send the S-Record file by pressing the <Page Up> key. Follow
the onscreen instructions to select the S-Record file for transfer, using ASCII transfer
protocol.
Upon completion of the S-Record file transfer, the D-Bug12prompt is displayed.
KERMIT FOR DOS — IBM PC
Setup
To set up Kermit using DOS on an IBM-compatible PC for use as the EVB terminal, first refer to
section 3.2 for the EVB startup procedure, which is inter-related with this example. Then follow
these steps:
1. At the DOS prompt, invoke Kermit by typing:
kermit<ENTER>
2. Set the baud rate to 9600 (or the customized EVB setting) by typing:
set baud 9600<ENTER>
3. Connect to the EVB by typing:
connect<ENTER>
4. Reset the EVB by pressing S1 or by activating the appropriate custom reset circuitry.
The D-Bug12 prompt should appear on the display.
procedure in section 3.2.
S-Record Transfers to EVB Memory
To load an S-Record file from the host computer into EVB memory using Kermit on an IBM-
compatible host computer, first verify that the host is correctly configured and operating as the
EVB terminal. Then follow these steps:
1. At the D-Bug12 prompt, enter the LOAD or VERF command with any parameters.
2. "Escape" from the D-Bug12 prompt and start the Kermit file transfer by typing:
<CTL-]>c
push<ENTER>
type <filename> > com1<ENTER>
Upon completion of the S-Record file transfer, the D-Bug12 prompt is displayed.
68EVB912B32UM/D
COMMUNICATIONS PROGRAM EXAMPLES
Continue with the startup
B-3
Advertisement
Table of Contents
