Service (Fan Speed, Ghost, Stripe) - Hitachi PJ-TX200 User Manual

Advanced Menu (OPTION menu)
Item
The projector has some additional functions as
follows.
Select an item using the ▲/▼ cursor buttons in the
SERVICE menu, and press the cursor ► button.
Then a dialog or sub-menu will appear.
FAN SPEED
Using the ▲/▼ cursor buttons changes the rotation
speed of the built-in cooling fans.
The HIGH mode is for use at high elevations.
- NOTE -
• HIGH mode may shorten the lifetime of the lamp. Except for use at
high elevations, please use the NORMAL mode.
• Note that the projector is noisier when HIGH is selected.
GHOST
If a ghost image appears, the following adjustment
may resolve it.
(1) Select a color element using the ◄/► cursor buttons in the
SERVICE
(2) Adjust the selected color using ▲/▼ cursor buttons to remove
STRIPE
Vertical stripes may appear on the screen with some signals. This is
not a hardware failure but a phenomenon common to LCD panels.
The following procedure may improve the stripes, although it may
not correct them completely.
Make adjustments while referring to the test
pattern displayed in the background of the menu or
dialog.
(1) Select a color element using the ▲/▼ cursor
(2) Press the ► cursor button and a dialog will
(3) Select H or L using the ◄/► cursor buttons.
(4) Adjust the tone of selected color using the ▼/▲ cursor buttons to
Be sure to make adjustments for every color element.
(Continued on next page)
54
FAN SPEED  GHOST  STRIPE

FACTORY RESET  FILTER MESSAGE
HIGH  NORMAL
GHOST menu.
R (Red)  G (Green)  B (Blue)
the ghost image.
buttons in the STRIPE menu.
R (Red)  G (Green)  B (Blue)
appear.
L (Dark side)  H (Bright side)
improve the stripes.
Description

SERVICE
FANSPEED NORMAL
GHOST
STRIPE
FILTER MESSAGE 100h
FACTORY RESET
FANSPEED
HIGH
NORMAL
R G B
+0 +0 +0
GHOST
STRIPE
Low High
STRIPE
STRIPE R: +0 +0
Low High
Low High G: +0 +0
R: +0 +0
R: +0 +0 +0 +0
B:
G: +0 +0
G: +0 +0
B: +0 +0
B: +0 +0
↓
↓
↓
L H
+0 +0 L H
L H
+0 +0
STRIPE G
+0 +0
STRIPE G
STRIPE G