Image Menu; Aspect, Over Scan - Hitachi PJ-TX200 User Manual

IMAGE menu

The following functions are accessible via the
IMAGE menu. After selecting an item according to
the procedure described in the preceding "Advanced
Menu operation" section (35), refer to the following
table for details on operating the selected item.
Item
Using the ▲/▼ cursors buttons changes the aspect ratio.
 For a computer (RGB) signal
 For an HDMI signal
 For a video, s-video or component video signal
 For no signal or an unrecognized signal
ASPECT
- NOTE -
• The NORMAL mode uses the signal's original aspect ratio.
• Performing an automatic adjustment initializes the aspect ratio
setting.
• The ASPECT function can also be accessed using the ASPECT
button on the remote control (24) or via the EASY MENU (31).
Using the ▲/▼ cursor buttons adjusts the over-scan ratio.
- NOTE -
• The OVER SCAN function can only be used for video, s-video or
OVER SCAN
component video signals.
• When this adjustment is too large, certain degradation may appear
on the border of the picture. If this occurs, readjust.
• The numbers displayed in the dialog and the IMAGE menu, are
just for your reference, and might not be the exact display ratio.
(Continued on next page)
NORMAL  4:3  16:9
NORMAL  4:3  16:9  WIDE  MOVIE1  MOVIE2 14:9
4:3  16:9  WIDE  MOVIE1  MOVIE2  14:9
16:9 (fixed)
4:3 16:9
16:9
Example for
NORMAL
a 16:9 signal
Example for 4:3
NORMAL
a 4:3 signal
Large (Reduces the picture)  Small (Magnifies the picture)
Advanced Menu (IMAGE menu)
MENU [COMPUTER]
ASPECT 4:3
PICTURE
IMAGE OVER SCAN 5
INPUT V POSITION 25
H POSITION 142
SETUP
H PHASE 16
SCREEN
H SIZE 1344
OPTION
AUTO ADJUST
EASY MENU
Description
WIDE MOVIE1 MOVIE2
:SELECT
14:9
43