Hitachi PJ-TX200 User Manual page 57

A lamp has a finite product life. Using the lamp for long periods of the time could
cause the picture to become darker or the color tone to become poor. Note that
each lamp has a different lifetime, and some may burst or burn out soon after you
start using them.
Preparation of a new lamp and early replacement are recommended. To purchase
a new lamp, contact your dealer and tell the lamp type number = DT00665.
1.
Turn the projector off, and unplug the power cord. Allow the projector to cool
for at least 45 minutes.
2.
Prepare a new lamp. If the projector is mounted on the ceiling, or if the lamp
has broken, ask the dealer to replace the lamp.
Replacing the lamp by yourself
3.
After making sure that the projector has
adequately cooled, slowly turn the projector over
so that the bottom is facing up.
4.
Loosen the lamp cover screw (marked by the
arrow), then slide and lift the lamp cover.
5.
Loosen the 2 lamp screws (marked by the arrow),
and slowly lift the lamp by the handles.
Be careful when handling the lamp. Breaking the
lamp could cause injury and the release of gas
containing mercury.
6.
Insert the new lamp, and retighten the screws that
were loosened in the previous step to lock it in
place.
7.
Slide the lamp cover into place, and retighten the
lamp cover screw loosened in step 4.
8.
Please reposition and reconnect the projector (
12-17). Then turn the projector on (20).
9.
Reset the LAMP TIME in the OPTION menu (53).
(1) Press the MENU button to display a menu. If you are using the Advanced
Menu skip the next step (2).
(2) To switch from the EASY MENU to the Advanced Menu, select the "Go To
the Advanced Menu ..." item in the EASY MENU using the ▲/▼ cursor
buttons, then press the ► cursor button. The Advanced Menu will appear.
(3) Select the "OPTION" item in the left column of the Advanced Menu using
the ▲/▼ cursor buttons then press the ► cursor button.
Maintenance
Bottom
Screw
of the projector
Lamp cover
57