Advertisement
CP-S830W
CP-S830E
6. Service points
6 - 1 POINT
@ Before Removing the Drive Base
force, you may damage the connector linked with the RGB
Input Terminal Base. When
removing the Drive Base, first
insert a flat-blade screwdriver with its end protected with
adhesive tape etc. into the slot between the Drive Base and the
RGB Input Terminal Base. Then please move the screwdriver
in the direction of the arrow, in a way that it does not damage
the Drive Base.
A
@ Before Removing the RGB Input Terminal Base
PWB ASS'Y INPUT
TERMINAL RGB
When removing the RGB Input Terminal Base, the signal base
may bend and get damaged. When removing the RGB Input
Terminal
Base,
please
push
the signal
base
with a
screwdriver's grip etc. in a way that the base does not gel
y
damaged, then remove the RGB Input Terminal Base.
PWB ASS'Y INPUT
TERMINAL RGB
i
PWB ASS'Y SIGNAL
@ Before Replacing the Panel / Lens Prism
You should not replace separately the parts of the liquid crystal Pane! / Lens Prism because it works properly only
when used together. Therefore, regarding these parts, you can either replace part NO. 14, Panel / Lens Prism
Assembly, or send the whole unit NO. 14 back to Hitachi, where we will replace the malfunctioning part,
recondition the device and send it back to you. In that case please contact our distributor.
DISTRIBUTOR
HITACHI
- Do not disassemble the unit
because replacement of separate
parts is not possible.
- For repairs of the product, please
contact our distributor.
KS
i
ee
Replacement of G PanelReconditioning
Return
G Panel
~19—
Advertisement
