Throttle Cable Removal And Installation; Throttle Cable Inspection; Throttle Cable Play Inspection And Adjustment - Suzuki kq750 2008 Service Manual

5) Remove the IAT sensor coupler (5) and PCV hose
(6).
Installation
Install the air cleaner box in the reverse order of
removal. Pay attention to the following points:
• Install the air cleaner box (1) and tighten the throttle
body clamp screw. Refer to "Throttle Body
Construction (Page 1D-8)".
• Tighten the air cleaner box mounting bolts to the
specified torque.
Tightening torque
Air cleaner box mounting bolt (a): 4.5 N·m (0.45
kgf-m, 3.0 lb-ft)
• Install the removed parts.
5
6
I831G1140014-01
1
(a)
1
(a)
I831G1140015-02

Throttle Cable Removal and Installation

Removal
1) Remove the front fender. Refer to "Front Side
Exterior Parts Removal and Installation in Section
9D (Page 9D-6)".
2) Remove the right handlebar switch box. Refer to
"Handlebars Removal and Installation in Section 6B
(Page 6B-3)".
3) Remove the throttle cable as shown in the cable
routing diagram. Refer to "Throttle Cable Routing
Diagram (Page 1D-1)".
Installation
Install the throttle cables in the reverse order of removal.
Pay attention to the following points:
• Install the throttle cable as shown in the cable routing
diagram. Refer to "Throttle Cable Routing Diagram
(Page 1D-1)".
• Check the throttle cable play and proper operation.

Throttle Cable Inspection

Check that the throttle lever moves smoothly from full
open to full close. If it does not move smoothly, lubricate
the throttle cable.

Throttle Cable Play Inspection and Adjustment

Refer to "Throttle Cable Play Inspection and Adjustment
in Section 0B (Page 0B-15)".
Engine Mechanical: 1D-6
B831G21406005
B831G21406006
B831G21406007