5A-14 Automatic Transmission:
• Compress the spring (7) with the special tool.
Special tool
(B): 09922–31430 (Clutch spring
compressor)
NOTE
Make sure to insert the spring end "A" into
the slot "B" of the special tool as shown in
the figure.
(B)
• Tighten the movable driven face ring nut (10)
temporarily.
• Remove the special tool from the movable driven face
assembly.
7
I831G1510047-02
"B"
"A"
I831G1510048-01
(B)
10
I831G1510049-01
• Tighten the movable driven face ring nut (10) to the
specified torque with the special tools.
Tightening torque
Movable driven face ring nut (a): 110 N·m (11.0
kgf-m, 79.5 lb-ft)
Special tool
(C): 09917–23711 (Ring nut wrench)
(D): 09924–52450 (Fixed driven face holder)
Drive V-belt Inspection
Inspect that the drive belt is free from any greasy
substance.
Inspect the contact surface of the drive belt for cracks or
damage and measure the width of the drive belt with the
vernier calipers.
If any defects are found or measurement exceeds the
service limit, replace the drive belt with a new one.
CAUTION
!
If grease or oil is present on the surface of
the drive belt, degrease the belt thoroughly.
Drive V-belt width
Standard: 34.3 (1.35 in)
Service limit: 33.3 mm (1.31 in)
Special tool
(A): 09900–20101 (Vernier calipers (1/15 mm,
150 mm))
(A)
(C)
10
(a)
(D)
I831G1510050-01
B831G25106008
"a"
I831G1510051-02