Router> show interface list
IfName
-------------------------------------------------------------------
lo
lan
Description: The current setting of the Internet time restriction is displayed. See set internet access time for details.
Example:
Router> show internet access time
Day-of-the-week
Time-of-day
Description: This command displays system and SNMP related configuration. All of them can be
changed through individual commands, except for the S/W and H/W version numbers that are constant
for each version of the product.
Example:
Router> show system
System Name: Router
----------------------------------------------------------------------
system description:
system contact:
system location:
community string (read):
Trap generation:
Total Serial Ports: 1 S/W Version: 1.03
MAC Address:
Console Baud Rate : 19200
Console Timeout:
Remote Management State: Enabled
DHCP State:
IP RIP Mode:
IP address:
Private IP address: 192.168.168.230
Enabled features:
Description: The system log contains logs of various events of interest, depending on the log level set at
the time. Common events include login, a PPP connection goes up or down (log level 2), a frame relay
DLCI connection goes up or down (log level 2), ... as well as certain protocol progress messages for
Oper.
Type
State MTU Status Status Status
LOOPBACK
Up
ETHERNET
Up
show internet access time
: Mon-Sat
: 13:30- 5:00
show system
Up Time: 0 months 1 days 21:21:05
IP Brouter Over ISDN Line
Unknown
Unknown
public
Disabled
00-60-20-10-00-70
10(min)
Enabled
Active Ver.1
0.0.0.0
HTTP Compression SNMP Filter NAS CLI L2L Bridging
show system log
IP
BRG
1536 Enable Disable
1500 Enable Enable n/a
H/W Version: 1.0
Learning State:
Enabled
network mask: 0.0.0.0
network mask: 255.255.255.0
84
Comp.
n/a