Router> show dhcp
Description: This command displays the entries currently configured in the Static DHCP Assignment
Table
Example:
Router> show dhcp table
Description: This command displays the upper and lower bound addresses currently being used for the
dynamic assignment of private IP addresses to DHCP clients and dial in users. (See "set range", above)
Example:
Router> show range
IP address assignment range: 192.168.168.1 – 192.168.168.254
Diagnostic Commands
Description: For switched profiles, this command activates the profile as if a trigger occurred. This
command has no effect on leased line profiles.
Description: This command disables the debug trace messages.
Description: For active switched profiles, this command terminates the connection as if an idle timeout
occurred. This command has no effect on leased line profiles.
Admin Status:
Enable
Network address: 192.168.168.0
Default gateway: 192.168.168.230
Primary DNS:
199.191.129.139
Primary WINS:
63.221.98.5
Node Type
h-node
IP-Address
Mac-Addr
-----------------------------------------------------------------
192.168.168.134
00400535db4f 06-15-99 14:24:5
192.168.168.254
222222222222
show dhcp table
Static DHCP Assignments
Name
IP-Address
----------------------------------------------------------------
daniel
192.168.168.134
show range
connect profile <Profile Name>
disconnect profile <Profile Name>
Default Lease: 10 hours
Netmask:
255.255.255.0
Secondary DNS:
199.191.144.75
Secondary WINS:63.221.98.7
Lease-Expires
Static
06-15-99 16:43:7
Mac-Address
00-40-05-35-DB-4F
disable trace
57
Entry Type
Dynamic