Chapter 3
Moreover, be sure that the separation front guide [7] is mounted so that the
wider side of the sheet [8] is toward the pickup roller side.
3.4.3 Separation Plate/Separation Pad
3.4.3.1 Before Removing the Separation Plate/Separation
Pad
1) Remove the inside cover. (page 3-2)Reference[Removing the Inside
Cover]
2) Remove the pickup roller unit. (page 3-5)Reference[Before Removing
the Pickup Roller Unit]
3.4.3.2 Removing the Separation Plate/Separation Pad
1) Remove the separation plate [2] and the separation pad [3].
- 2 screws [1]
[1]
[2]
3.4.3.3 Adjusting the Separation Pressure
MEMO:
Make the following adjustments if such feeding faults as multiple feeding
occur.
Pressure adjusting
roll
Side A
Side B
1) Turn over the pressure adjusting roll [1] (found fitted to the spring), and
fit it in place (turn it over from side A to side B).
When fitting the spring in place, be sure it is oriented correctly, i.e., the
3-6
[3]
F-3-30
T-3-1
Separation pressure
low
high
[1]
F-3-31
spring [1] with a bend being upstream in relation to feed direction.
0017-6419
[1]
0017-6425
3.4.4 No.1 Registration Roller Roll
3.4.4.1 Before Removing the No. 1 Registration Roller
Roll
1) Remove the front cover. (page 3-1)Reference[Removing the Front Cov-
er]
2) Remove the feeder cover. (page 3-2)Reference[Removing the Feeder
Cover]
3.4.4.2 Removing the No. 1 Registration Roller Roll
1) Remove the cover [2].
- 4 screws [1]
0017-6428
2) Remove the support plate; then, detach the No. 1 registration roller roll
[2].
- 1 screw [1]
F-3-32
[1]
[2]
F-3-33
[2]
[1]
F-3-34
0017-6432
0017-6436