Removing The Pickup Motor; Feed Motor; Before Removing The Feed Motor; Removing The Feed Motor - Canon DADF-M1 Service Manual

3.3.1.2 Removing the Pickup Motor

1) Remove the pickup motor [3].
- 1 connector [1]
- 2 bind screws [2]
[2]
[3]
When mounting it, be sure that the timing belt is properly attached to the pul-
ley.

3.3.2 Feed Motor

3.3.2.1 Before Removing the Feed Motor

1) Remove the rear cover. (page 3-2)Reference[Removing the Rear Cover]

3.3.2.2 Removing the Feed Motor

1) Remove the harness from the harness guide [3].
- 1 screw [1]
- 4 connectors [2]
2) Remove the cooling fan [3].
- 1 screw [1]
- 1 connector [2]
[2]
3) Loosen the 2 screws [1], and move the feed motor [2] down; then, tighten
the 2 screws [1] you have loosened.
[1]
[2]
F-3-11
[2]
[2] [1]
[3]
F-3-12
[1]
[3]
F-3-13
0017-6424
When mounting it, loosen the screws [1] to put it back to its initial position.
4) Removing the feed roller [3].
- 1 connector [1]
- 2 screws [2]
[1]
0017-6326
0017-6329
When mounting it, be sure that that timing belt [1] is properly attached to the
pulley [2].

3.3.3 Delivery Reversal Motor

3.3.3.1 Before Removing the Delivery Reversal Motor

1) Remove the rear cover. (page 3-2)Reference[Removing the Rear Cover]

3.3.3.2 Removing the Delivery Reversal Motor

1) Remove the harness from the harness guide [3].
- 1 screw [1]
- 4 connectors [2]
[2]
[1] [1]
F-3-14
[3]
[2] [2]
F-3-15
[2]
[1]
F-3-16
Chapter 3
0017-6460
0017-6464
3-3