Chapter 3
Cover]
3.4.6.2 Removing the No. 2 Registration Roller Roll
1) Remove the cover [2].
- 4 screws [1]
2) Remove the support plate; then, detach the No. 2 registration upper roller
roll [2].
- 1 screw [1]
3.4.7 No.2 Registration Roller
3.4.7.1 Before Removing the No. 2 Registration Roller
1) Remove the front cover. (page 3-1)Reference[Removing the Front Cov-
er]
2) Remove the rear cover. (page 3-2)Reference[Removing the Rear Cover]
3) Remove the cooling fan. (page 3-17)Reference[Removing the Cooling
Fan]
3.4.7.2 Removing the No. 2 Registration Roller
1) Loosen the 2 screws [1], and move down the feed motor [2]; then, tighten
the 2 screws you have loosened [1].
[1]
3-8
[1]
[2]
F-3-42
[1]
[2]
F-3-43
[2]
[1]
F-3-44
When mounting it, be sure to loosen the screws [1] and move the feed motor
[2] back into its initial position.
2) Remove the feed motor unit [3].
0017-6491
- 4 screws [1]
- 1 connector [2]
[1]
When mounting it, be sure that the timing belt [1] is properly attached to the
pulley [2].
3) Detach the No.2 registration roller [4].
- 3 E-rings [1]
- 3 gears [2]
- 2 bushings [3]
[2]
0017-6495
0017-6505
[4]
[3]
[2]
F-3-45
[2]
[1]
F-3-46
[1]
[3]
[1]
[1]
[3]
[2]
F-3-47
[1]