User Error Code; Alarm Code - Canon DADF-M1 Service Manual

Chapter 5
Code
E413

5.2 User Error Code

5.2.1 Alarm Code

The machine flashes the original detection LED at intervals of 240 msec when it identifies a fault as being an alarm condition.
Code
xx03
xx11
xx13
xx14
5-2
Detail code Item Description
The level of the locking HP sensor does not change within a specific period of time.
Cause: there is a fault in the locking motor or the driver PCB; there is a fault in the locking HP sensor;
there has been an increase in the load of the locking cam.
0001 Read roller 1 open The level of the locking HP sensor does not change within a
specific period of time after the locking motor has been driven.
0002 Read roller 1 close The level of the locking HP sensor does not change within a
specific period of time after the locking motor has been driven.
Fault
Separation has failed.
The number of jam recovery sheets is
greater than the number of originals.
An original has been pulled out.
High-speed duplexing operation fails. The original is longer than the specified limit.
T-5-3
Description
The 1st original does not reach the post-separation sensor.
The 1st original does not reach the registration sensor.
In jam recovery mode, the tray runs out of originals before as
many as 'the number of recovery sheets - 1' has been delivered.
The read sensor is off when the preceding original has been
moved to a point of reading.
0004-5177