Powercut 1300/1600 Mechanized Plasma; Section 4; Optional Accessories; Section 2 - ESAB PowerCut 1300 Instruction Manual

SECTION 2

DESCrIPTION
2.5

Optional Accessories:

Torch Holder Assembly ........................................................p/n 0558005926
remote Hand Switch with 25 ft. (7.6 m) lead .............. p/n 0558008349
50 ft. (15.2m) lead ............ p/n 0558009277
Enables non-automated mechanized cutting using the PT-37 torch.
Can be used on machines equipped with or without CNC interface
connection pigtail. Connects to the torch cable receptacle through
the front panel access door strain relief.
remote Hand Switch with 25 ft. (7.6 m) lead .............. p/n 0558005548
50 ft. (15.2 m) lead ........... p/n 0558005549
Enables non-automated mechanized cutting using the PT-37 or PT-38
torch. Can only be used on machines equipped with CNC interface
connection. Connects to the CNC interface pigtail on the rear panel.
CNC Cable 25 ft. (7.6 m) ....................................................... p/n 0558008833
50 ft. (15.2 m) .................................................... p/n 0558008834
Connects between the CNC interface pigtail on the rear panel and the
CNC.
gas flow Measuring Kit .............p/n 19765 ("CE" units - 0558000739)
Valuable troubleshooting tool allows measurement of the actual air
flow through the torch.
Powercut-900/1300/1600 Water Separator ........... p/n 0558007897
Improves air quality by removing water.
PowerCut 1300/1600 Mechanized Conversion kit ..................................... p/n 0558007885
Adds automated mechanized capability to an existing manual machine. Refer to mechanized section of this manual for
CNC Interface connection. Requires software version 1.04 or higher (displayed during power-up). Refer to Section 4,
Subsection 4.1.E1. Contact factory for any required software updates.
44