Reset; Download Procedure - SATO M-5900RV Operator And Technical Reference Manual

Appendix E. Custom Protocol Command Codes

Reset

If the custom Protocol Command codes are incorrect or if the printer does not
respond to commands using the custom set, the Alternate Protocol Control Codes
can be restored by the following procedure.
1. Turn the printer off.
2. Place DIP switch DS2-7 in the ON position.
3. Turn the power ON while simultaneously pressing the .EED and LINE
switches.
4. When the message "ALT PROTOCOL DE.AULT COMPLETED" appears on the
display panel, turn the printer off.
5. When it is powered up again, the Alternate Protocol Command Code set will
be active and all previous custom settings will be lost.

Download Procedure

The procedure for downloading a custom Protocol Command Code set is:
1. Reset the printer to the default settings using the Reset procedure above.
2. Place DIP switch DS2-7 in the ON position.
3. Turn the power on while simultaneously pressing the LINE switch. This
places the printer in the USER DOWNLOAD mode as signified by a "User
Download" displayed on the LCD panel.
You will hear a single "beep" signifying the printer is in the User Download
mode.
4. Press the LINE key to place the printer in the On-Line mode.
NOTE: There is no visual indication (nothing displays) that you have
performed this operation, however, the printer is now ready to receive the
download command data stream.
5. Send the appropriate data stream to the printer, (see example, next page).
Page E-2 SATO M-5900RV Operator and Technical Reference Manual
ALT PROTOCOL
DE.AULT COMPLETE
USER DOWNLOAD
PN 9001081
Rev. C