North American Isdn Menu; Figure 4-4. Menu 2 - Isdn Setup (North America) - NETGEAR RT338 Reference Manual

Reference Guide for the Model RT338 ISDN Router

North American ISDN Menu

Use the commands described in
America. Figure 4-4
Switch Type= AT&T 5ESS NI-1
B Channel Usage= Switch/Switch
1st Phone #=
2nd Phone #=
Edit Advanced Setup= No
Press ENTER to Confirm or ESC to Cancel:
Figure 4-4. Menu 2 - ISDN Setup (North America)
Table 4-3 lists and describes each field in the menu and how to enter the information in each field.
Table 4-3. ISDN Setup Menu Parameters for North America
Field
Switch Type
B Channel Usage
SPID Number(s)
Telephone
Number(s)
Analog Call
Edit Advanced Setup This field selects the ISDN Advanced Setup Menu. Use the SPACE bar to toggle this
4-8
Table 4-1
shows Menu 2 - ISDN Setup.
Menu 2 - ISDN Setup
SPID #=
Incoming Analog Call= Phone 1
SPID #=
Incoming Analog Call= Phone 2
Description
Verify and select the switch type with the telephone company. Press the space bar to
cycle through the choices. Press [Enter] to select. If your line is configured for
National ISDN (NI-1) Protocol, choose the NI-1 setting. Otherwise, choose Custom.
Switch/Switch should be selected unless one or both B channels are a leased circuit.
Use the Space bar to cycle through all combinations of Switch, Leased, and Unused.
SPID is a number used by a switch for identification purposes. Depending on the
switch type, there may be zero, one, or two SPIDs assigned to a line. These numbers
are provided by the telephone company.
Enter the telephone number(s) assigned to your ISDN line by the telephone
company. For North America, a phone number is usually in a standard seven-digit
local format, without the area code (for example, 5551212). Include 1+area code if it
is required for local dialing. Enter only digits, and do not include dashes ( - ) and
spaces in this field. This field should be no longer than 19 digits.
This field tells the router how to route an incoming analog call.
• Set to Phone 1 to route the incoming analog calls to the PHONE 1 port.
• Set to Phone 2 to route the incoming analog calls to the PHONE 2 port.
• Set to DOVBS to receive the incoming data over voice bearer service call.
field to Yes. Press [Enter] to display Menu 2.1 - ISDN Advanced Setup. For more
information about this menu, see
and Table 4-2 to display the ISDN Setup menu for North
ISDN Advanced Setup Menu (North America).
Initial Router Configuration