Maintenance - Chicago Electric 98265 Owenrs Manual

Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURy FROM AccIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
TO PREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
cleaning the Saw
1. With the saw turned off and the cord pulled out
from the outlet, wipe down all of the external parts
of the unit with a damp (not dripping wet) sponge.
2. Make sure that the Water Tray is also cleaned and
a container of some type is located below the Drain
Plug (E03). Remove the plug and drain the water
and silt accumulated by the cutting operation.
3. Use more water to clean out the
residual silt from the water tray.
4. Replace the Drain Plug. Check condition of
the O-Ring (E02) and replace if torn or cut.
Page 12 For technical questions, please call 1-888-866-5797.
2. AFTER USE, wipe external surfaces of the tool
with clean cloth. Drain water from the water tray
and wash out any residue from the sump pump.
WARNING! If the supply cord of this
3.
power tool is damaged, it must be replaced
only by a qualified service technician.
5. The cleaning process is faster and easier
if the unit is tipped on end and carefully
(do not wet the motor) hosed down.
6. Wipe the entire unit down including the
sides and Sliding Bars (C16).
7. Clean out the pump by removing the Filter (A26),
placing the pump into a container of clean water, and
running it to pump out any remaining silt. Back flush
the screen Filter (A26) and replace onto the pump.
Item 98265