Maintenance - Chicago Electric 36595 Assembly And Operating Instructions Manual

The following Steps should be followed after every use of your Reciprocating Saw. This will
prolong the life of your tool and ensure safe operation.
Step 1: Unplug the Saw. Do not attempt any maintenance on the Saw when it is plugged in.
Step 2: To prevent the motor from overheating, clean the motors ventilation slots as shown in
Figure 6.
Step 3: Make sure the Blade is not worn or damaged. If the Blade is damaged or worn, replace
with approved replacement parts from Harbor Freight Tools.
Step 4: Wipe down the tool after every use. This will allow you to see if there is damage to the
Saw or the plastic case. If you find damage, return the Saw to Harbor Freight Tools for
repairs. Do not attempt repairs yourself.
Step 5: Over time, the CARBON BRUSHES (#32) in the Motor will wear. If the CARBON
BRUSHES wear too much, the Saw will not work. Take the Saw to Harbor Freight Tools
or a qualified technician for service.
Page 9 -- SKU: 36595

MAINTENANCE

Figure 6 — Cleaning Ventilation Slots
Ventilation Slot