Maintenance - Chicago Electric 40315 Owner's Manual & Safety Instructions

Maintenance and Servicing
procedures not specifically explained
in this manual must be performed
only by a qualified technician.
procedures.
tO prEVEnt SEriOuS inJury FrOM tOOL FaiLurE:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance,
and Lubrication
1. BEFOrE EacH uSE, inspect the general
condition of the tool. Check for loose screws,
misalignment or binding of moving parts,
cracked or broken parts, damaged electrical
wiring, loose or worn out blade, and any other
condition that may affect its safe operation.
2. aFtEr uSE, clean external surfaces of the
tool with clean cloth. Drain water from the
water tray and wash out any residue.
3. tool service must be performed only
by qualified repair personnel. Service
or maintenance performed by unqualified
personnel could result in a risk of injury.
4. When servicing a tool, use only identical
replacement parts. Follow instructions in
the "Inspection, Maintenance, And Cleaning"
section of this manual. Use of unauthorized
parts or failure to follow maintenance instructions
may create a risk of electric shock or injury.
5. WarninG! if the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
6. WarninG! turn the power Switch (21)
off and unplug the tool from its
electrical outlet before performing any
inspection, maintenance, or cleaning.
Page 12
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
turn the power Switch of the tool to its "OFF" position and unplug the tool from its
electrical outlet before performing any inspection, maintenance, or cleaning
For technical questions, please call 1-888-866-5797.
7. to install a cutting Wheel Blade:
A. Make certain power is disconnected and
the power switch is in the "OFF" position.
B. Empty the Tray (17). Turn it 90°
(sideways) and remove it.
C. Remove the Screws (2) and Washers (3).
Remove the Front Cover (1),
and Rear Blade Cover (58).
D. Use the prongs on the Spanner Wrench (54)
to hold the Outside Flange (7)
while you use the Nut Driver (55) to
remove the Arbor Bolt (4). Remove
the old Cutting Wheel Blade.
E. Install a new 7" Continuous Rim Diamond
Blade (not included, sold separately),
making sure to install Blade according to
indicated rotation direction on Blade.
F. Replace the Outside Flange and Arbor Bolt.
Use the Spanner to hold the Outside Flange
while you tighten the Arbor Bolt securely
with the Nut Driver. Do not overtighten.
G. Replace the Front Cover, Rear Blade
Cover, Screws, Washers, and Tray
in the reverse order of removal.
8. to clean: Wipe with a damp cloth, vacuum or
use compressed air. Do not use solvents.
9. When storing: Store the Tile Saw in a
safe, clean, dry, location out of reach of
children and other unauthorized people.
10. cautiOn! All maintenance, service, or
repairs not listed in this manual are only to be
attempted by a qualified service technician.
Item 40315