FIGURE 10.2 Engaging/Disengaging Motor Release Lever
Removing/Installing Casters
NOTE: For this procedure, refer to FIGURE 10.3.
NOTE: Front and rear casters are replaced in the same manner.
Periodically, the tires will need to be replaced due to wear or puncture.
Removing
1. Remove the mounting screw, two spacers and locknut that secure the existing caster
to the fork.
2. Remove the existing caster from the fork.
Installing
1. Position the new/existing caster into
the fork.
2. Reinstall the mounting screw, two
spacers and locknut. Securely tighten.
3. Torque locknut to 10 ft‐lbs (120 in‐lbs).
4. Loosen the locknut 1/8 of a turn.
5. Move the caster side to side.
NOTE: If the caster moves side to side, tighten
the locknut slightly. Repeat STEP 4 until there
is no side to side movement of the caster.
Part No. 1143206
SECTION 10—SHROUD AND WHEELS
Motor Release Levers
Engaged
Disengaged
Fork
Mounting
Screw
Spacer
FIGURE 10.3 Removing/Installing Casters
51
Locknut
Spacer
Caster
Pronto® M41 with SureStep®