Repositioning the Joystick
NOTE: For this procedure, refer to FIGURE 11.2.
NOTE: Take note of position and orientation of mounting hardware for reinstalling the joystick
assembly.
1. Turn the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
2. Remove the joystick from the wheelchair.
3. Remove the three hex mounting screws, spacers and locknuts that secure the
mounting bracket to the three mounting holes on the arm frame.
NOTE: The mounting bracket is mounted to the inside of the arm frame.
4. Reposition the mounting bracket on the opposite arm frame.
5. Using the three hex mounting screws, spacers and locknuts secure the mounting
bracket to the three mounting holes of the arm frame.
6. If necessary, perform the following to reposition the adjustment lock:
A. Slide the adjustment lock from the mounting bracket.
B. Rotate adjustment lock 180° and slide adjustment lock over the opposite end of the
mounting bracket.
7. Slide joystick mounting tube through the mounting bracket to the desired position
and secure adjustment lock to tube by turning lever on adjustment lock.
Mounting Bracket
Adjustment Lock Lever
Armrest Plate
Locknuts
Part No. 1143206
Spacers
FIGURE 11.2 Repositioning the Joystick
55
SECTION 11—ELECTRONICS
Hex Mounting Screws
Mounting Holes on Arm
Frame
Pronto® M41 with SureStep®