Section 11-Electronics; Removing/Installing The Joystick; Removing; Installing - Invacare Pronto M41 Owner's Manual

SECTION 11—ELECTRONICS
SECTION 11—ELECTRONICS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.

Removing/Installing the Joystick

NOTE: For this procedure, refer to FIGURE 11.1.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 56.
2. Cut the tie‐wraps that secure the joystick cable to the arm.
3. Loosen the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
4. Remove the joystick and joystick mounting tube from the mounting bracket.

Installing

1. Slide joystick mounting tube through the mounting bracket to the desired position.
2. Tighten the adjustment lock lever to secure the joystick mounting tube to the
mounting bracket on the other arm.
3. Tie‐wrap the joystick cable to the arm (Detail "A").
4. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 56.
Seat
Standard Arm
Mounting Bracket and
Adjustment Lock Lever
Pronto® M41 with SureStep®
WARNING
Joystick
Mounting
Tube
Mounting
FIGURE 11.1 Removing/Installing the Joystick
DETAIL "A" - TIE-WRAP
Joystick
Screws
Tie-Wrap Here
54
LOCATIONS
Seat
Tie-Wrap Here
Standard
Joystick
Arm
Joystick
Cable
Part No. 1143206