AXLE GEOMETRY (SETTING AT REFERENCE HEIGHT)
WARNING : The checks of the front and rear axle geometry values, as well as the adjusting of the front suspension should be carried out
at precise positions of suspension compression (reference height) on a suspension test bed
Lock the steering rack at point zero: straight ahead (See corresponding operation).
[1] Set of two compressors
[2] Set of two shackles
[3] Set of four straps
[4] Set of two slings
[5] Under body height gauge
Setting at reference height
Requirements prior to setting at reference height
Check the pressures in the tyres.
Check the conformity of the tyres.
Remove the wheel trims.
Tooling required
: 9511-T.A
: 9511-T.C
: 9511-T.B
: 9511-T.D
: 2305-T
277
C8