C8
Tools.
[1] Tensioning lever
[2] Peg for dynamic roller Ø 4 mm
[3] Peg for dynamic roller Ø 2 mm
[4] Dynamic roller compression lever
(A) Pegging hole.
(B) Belt wear check mark (fixed on engine).
(C) Zero wear mark.
E5AK0E9C
(D) Maximum wear mark.
This marking system permits checking of the belt wear; if the marks (D) and (B) coincide, it implies that the belt
requires replacing.
Tighten the screw (1) to 4,5 ± 0,4 m.daN.
Removing.
Remove:
- The front RH wheel.
- The front RH splash-shield.
- The under-engine shield.
IMPERATIVE : Mark the direction of rotation of the belt if to be re-used.
B3EK0DHD
AUXILIARY EQUIPMENT DRIVE BELT
Engines : RHT - RHW
104
: (-).0188-J2.
: (-) 0188-Q1.
: (-).0188-Q2.
: (-).1888-Z.