If The Target Image Is Not Projected; Turning Off - Epson EH-TW9200W User Manual

Basic Operations

If the Target Image is not Projected

If the image is not projected, you can change the source using one of the following methods.
Remote control
Press the button for the target port.
c
•
For video equipment, start playback first and then change the source.
•
If the color looks unnatural when changing to a Video or Component source, check that the port you
have connected to is the same as the Input Signal.
Component p.73

Turning Off

a
Turn off the connected equipment.
c
When Power Off Link is set to
On in the HDMI Link menu,
turning off HDMI CEC compatible
equipment may also turn off the
projector.
Link - Power Off Link
b
Press the button on the remote
control or the projector's control
panel.
Remote control
A confirmation message is displayed.
Settings - HDMI
s
p.70
Control panel
Control panel
Press the button and select the target port.
Press the button to confirm the selection.
Extended - Input Signal - Video Signal/
s
c
Press the
Projection ends, and the lens shutter closes
automatically.
c
When Standby Confirmation is
set to Off, you can turn off the
projector by pressing the
button on the remote control
once.
Standby Confirmation
d
Wait until cool-down is complete.
The operation indicator on the projector's
control panel stops flashing.
e
Disconnect the power cord.
c
If the power cord is connected,
some electricity is consumed even
if no operations are made.
26
button again.
Extended - Display -
s
p.73