Configuration Menu
Memory menu
Function
Load Memory
Save Memory
Erase Memory
Rename Memory
Info menu
Function
Lamp Hours
Source
Input Signal
Resolution
Scan Mode
Refresh Rate
3D Format
Sync Info
Deep Color
Video Signal
Status
Serial Number
Version
*
The cumulative use time is displayed as "0H" for the first 10 hours. 10 hours and above is displayed as "10H",
"11H", and so on.
Reset menu
Function
Reset All
Reset Memory
Reset Lamp Hours
Loads settings saved using the Save Memory function.
This cannot be selected if you have not saved any settings with the Save Mem‐
ory function.
Saves certain Image and Signal settings to memory.
Erases settings saved to memory that you no longer need.
Renames a saved memory.
Displays the cumulative lamp operating time
Displays the source name for the connected equipment currently being projec‐
ted.
Displays the content of Input Signal set in the Signal menu according to the
source.
Displays the resolution.
Displays the scan mode.
Displays the refresh rate.
Displays the 3D format of the signal input during 3D projection (Frame Packing,
Side by Side, or Top and Bottom).
Displays the image signal information.
This information may be needed if service is required.
Displays deep color.
Displays the settings for Video Signal in the Extended menu.
This is information about errors that have occurred on the projector.
This information may be needed if service is required.
Displays the projector's serial number.
Displays the firmware version of the projector.
Resets all items in the Configuration menu to their default settings.
The following items are not reset to their defaults: Input Signal - Component,
Panel Alignment, Lamp Hours, Language, Save Memory.
Erases all settings saved using the Save Memory function.
Resets the cumulative lamp hours use time to 0 H. Reset when you replace the
lamp.
75
Explanation
p.43
s
Explanation
*
.
Explanation
p.43
s
p.42
s
p.43
s