Replacing Non-Hot-Plug Components; Opening Server Blade And Identifying Defective Css Component - Fujitsu PRIMERGY BX620 S6 Operating Manual

Replacing non-hot-plug components

8.2 Replacing non-hot-plug components
If a defective non-hot-plug component (for more information, see the manual
"PRIMERGY ServerViewSuite Local Service Concept - LSC" on the
PRIMERGY ServerView Suite DVD 2) was detected, proceed as follows:
Ê Exit all applications and shut down the server blade correctly.
Ê Press the On/Off button on the server blade control panel.
Ê Pull the server blade out of the basic unit (see
from the basic unit" on page
Ê Open the server blade (see
Ê Press the Indicate CSS button on the system board (see
components" on page
The PRIMERGY diagnostic LED (see service supplement) of the defective
CSS component glows orange and shows which CSS component on the
system board must be replaced.
8.2.1 Opening server blade and identifying defective
CSS component
V
CAUTION!
Any unauthorized opening or improper repairs could damage the device.
Follow the safety instructions in chapter
page 25.
94
95).
"Removing the cover" on page
98).
Operating Manual
"Removing the server blade
97).
"Identifying CSS
chapter "Important notes" on
BX620 S6