Fujitsu PRIMERGY BX620 S6 Operating Manual page 50

Configuring a server blade
Ê Connect the data cable of the CD-ROM/DVD drive and the floppy disk drive
too, if required, to the USB ports of the breakout cable (see
page 41).
Ê Make sure the basic unit is switched on.
Ê Press the On/Off button on the control panel to switch the server blade on
(item 2 in figure 7 on page
Ê If the CD-ROM/DVD drive and the floppy disk drive are not to be supplied
with power via the USB hub of the breakout cable, connect them directly to
the power outlet.
Ê Connect the monitor, keyboard and mouse to the KVM blade on the rear of
the basic unit. You will find more information on this in the manual for the
basic unit.
Ê Press the KVM button (item 4 in
the server blade to switch the keyboard, mouse and monitor from the KVM
blade to the server blade.
Software preparation
Booting from the CD-ROM/DVD drive
Boot the relevant server blade from the ServerView Installation Manager CD to
install the operating system. To do this, you may need to change a number of
settings:
Ê Insert the ServerView Installation Manager CD in the CD-ROM/DVD drive
and press the On/Off switch (item 2 in
panel of the server blade.
Ê Press the KVM button (item 4 in
the server blade to switch the keyboard, mouse and monitor from the KVM
blade to the server blade. Wait a few seconds until the monitor is activated.
Ê Press [F2], when prompted, to call the BIOS Setup of the server blade.
Ê Select the Boot submenu in the BIOS Setup menu and enable Boot from CD-
ROM Drive.
Ê Press [ESC] twice and select Exit Saving Changes from the Exit menu.
After booting the server blade from the ServerView Installation Manager CD, the
startup screen is displayed.
50
44.)
figure 7 on page
figure 7 on page
figure 7 on page
Operating Manual
figure 6 on
44) on the control panel of
44) on the control
44) on the control panel of
BX620 S6