Switch Settings - NEC VERSA FX Service And Reference Manual

Note
The system switches are also located in the memory module bay. Therefore, if you
need to set any system switches, do it while the system is already disassembled.

Switch Settings

A six-position dip switch is located on the bottom of the system in the memory module bay. The
following list identifies each switch setting and its function.
!
Switch 1, Password Override Switch — The default setting is "OFF." If you forget your
password and cannot access the data on your NEC Versa, change the setting to "ON"
and your current password is erased.
!
Switch 2 — Keyboard select; Default is "ON" for U.S. 85 key keyboard.
!
Switch 3 — Reserved for factory use; Default is "ON."
!
Switch 4 — Keyboard select; Default is "ON" for U.S. 85 key keyboard.
!
Switch 5 — BIOS flash enable; Default is "OFF" (disable). Before updating your BIOS,
change the setting to "ON."
!
Switch 6 — Logo select; Default is "OFF" for U.S.
Default switch settings
Disassembly and Reassembly 3-5