Download Table of Contents Print this page

Rinse Aid; Setting Amount Of Rinse Aid; Switching The Rinse Aid Refill Indicator Off Or On - Siemens Dishwasher Operating Instructions Manual



Table of Contents

Rinse aid %

As soon as the rinse-aid refill
indicator X is lit on the fascia, there
is still a rinse-aid reserve of 1–2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness
is over 21° dH, rinse aid must be used.
– Open the cover on the rinse-aid
dispenser 1j. To do this, press
the mark (1) on the cover
and simultaneously lift
the cover on the control plate (2).
– Carefully pour in the rinse aid to just
below the edge of the filler opening.
– Close cover until it clicks shut.
– To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with
a cloth.

Setting amount of rinse aid

The rinse aid dispensing rate can be
adjusted steplessly. The clear rinse
controller was set to 4 at the factory.
Do not change the position of the rinse aid
control unless there are streaks (rotate
towards –) or water stains (rotate towards
+) on the utensils.
Switching the rinse aid refill
indicator off or on *
* depending on model
If the rinse-aid refill indicator X
is impaired (e. g. when using combined
detergents containing rinse aid
component), it can be switched off.
To change the setting:
– Close the door.
– Keep pressing the button #
and press main switch ( until
the digital display ` illuminates.
– Release buttons. On the digital display
is indicated (rinse-aid refill
indicator on).
– By pressing button # you can switch
the rinse-aid indicator off
– Switch off the main switch (;
the chosen setting has now been
or on .


Table of Contents

Table of Contents