Assembly - Bounty Hunter Quick Silver Owenrs Manual

ASSEMBLY

Adjusting the Arm Rest
The arm rest may be moved
forward or backwards by
removing the single screw and
nut, and then repositioning the
2-piece arm rest. Users with
shorter arms may find the arm
rest more comfortable in the
forward position. In order to
move the arm rest backwards,
the plastic plug must be
removed from the aluminum
tube.
Arm Rest Strap (not included)
Some users prefer to use a strap
when swinging the detector
vigorously, in order to hold the
detector secure against the arm.
The strap may be purchased as
an optional accessory.
The detector can also be used
without the strap with no
compromise to detector balance
and stability under most
conditions.
4
TROUBLESHOOTING
TROUBLESHOOTING GUIDE
SYMPTOM CAUSE
Detector chatters • Using detector
or beeps erratically indoors
• Using detector near • Move away
power lines
• Using 2 detectors in • Keep 2 detectors
close proximity
• Highly oxidized
buried object
• Environmental
electromagnetic
interference
Constant low tone • Discharged batteries • Replace batteries
or constant repeating • Wrong type of
tones batteries
LCD does not lock • Multiple targets
on to one target ID present
or detector emits • Highly oxidized
multiple tones target
• Sensitivity set
too high
No power, no • Dead batteries
sounds
• Cord not connected • Check connections
securely
• Not moving
Search Coil
SOLUTION
• Use detector
outdoors only
from power lines
at least 30' apart
• Only dig up
repeatable
signals
• Reduce sensitivity
until erratic
signals cease
• Use only 9V
alkaline batteries
• Move coil slowly
at different angles
• Reduce sensitivity
• Replace batteries
• Sweep search coil
from side-to-side
17