Bounty Hunter HandyMan Nail Finder S3019-H Operating Manual
Bounty Hunter HandyMan Nail Finder S3019-H Operating Manual

Bounty Hunter HandyMan Nail Finder S3019-H Operating Manual

Hand held metal detector

Advertisement

Quick Links

OPERATING MANUAL
HandyMan Nail Finder
®
Hand Held
Metal Detector

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HandyMan Nail Finder S3019-H and is the answer not in the manual?

Questions and answers

Summary of Contents for Bounty Hunter HandyMan Nail Finder S3019-H

  • Page 1 OPERATING MANUAL HandyMan Nail Finder ® Hand Held Metal Detector...
  • Page 2 OPERATOR DETECTION ALERTS INTERFERENCE ELIMINATION FEATURES • Audio alert – High pitch sound • 3 Operating frequency selections • Vibration alert - silent operation • Minimizes electromagnetic interference from other devices COMFORT GRIP NORMAL & REDUCED POWER SUPPLY SENSITIVITY • Requires (1) 9-Volt battery OPERATING FREQUENCY LED INDICATORS...
  • Page 3 4. Silent Operation Position the Silent/Audio switch in the "Silent/Vibrate" position and: a) The detector will NOT emit an audible tone upon the detection of metal objects. b) The vibrator will activate upon the detection of a metal object, and the "Target" LED indicator will illuminate.
  • Page 4 First Time Operation To Operate the Detector 1) Install the Battery a. Use a 9-volt ALKALINE battery only (battery not included) b. Install battery with correct polarity (align "+" on detector housing with "+" on battery) c. The battery cover opens and closes with a coin or screwdriver 2) Set the On switch to "ON"...
  • Page 5 Batteries Use 9-Volt ALKALINE battery only (battery not included) Low Battery Alert The Yellow LED indicator light will illuminate and remain illuminated when the batteries are discharged to the point at which the detector has lost 10% of its metal detecting range. The detector will continue to operate, at a lower sensitivity, when the Low Battery Indicator is illuminated.
  • Page 6 Power Switch with Low Mode The Power switch has 2 "ON" positions and a forward "OFF" position. The detector is OFF with the switch in the "UP" position The detector is ON with the switch in the "MIDDLE" position The detector is in LOW MODE operation with the switch in the "DOWN"...
  • Page 7 Scanning for the Detection of Metal Objects Always test the detector before operation. Sweep the detector across a known metal object, and verify detection with audio, vibratory, and visual feedback. Motion is Required: The metal detector must be IN MOTION, sweeping across the target area, to detect the presence of metal.

Table of Contents