Batteries - Bounty Hunter Quick Silver Owenrs Manual

BATTERIES

IMPORTANT:
Always use ALKALINE batteries only.
Do not use heavy duty batteries.
DON'T MIX OLD AND NEW BATTERIES
Always remove the batteries for prolonged storage.
CHECK THE BATTERIES if your detector exhibits any of the following
symptoms:
G
The unit does not turn on.
1
G
2 Low speaker volume.
G
Unit beeps continuously or erratically.
3
The LOW BATTERY indicator will come on and stay on if the batteries
are discharge. You may notice erratic beeping if using with LOW
BATTERY illuminated.
IMPORTANT:
Your Quick Silver metal detector requires two 9-Volt
ALKALINE batteries.
Follow these steps to install the batteries.
G
Carefully remove the battery compartment door by pressing the release
1
clip on the right side of the door.
G
Snap one
2
battery onto
each of the
terminals and
place the bat-
teries inside the
compartment.
Insert booth of
the batteries
with terminals
facing inward.
G
Replace the
3
compartment
door by carefully
inserting oppo-
site side of clip
first. Then press
6
Both Batteries
teminals
facing in
Release
Clip
IN THE FIELD TECHNIQUES
PINPOINTING
Accurate pinpointing takes practice
and is best accomplished by
"X-ing" the target area.
1. Once a buried target is indicated
by a good tone response,
continue sweeping the coil over
the target in a narrowing
side-to-side pattern.
2. Take visual note of the place on
the ground where the "beep"
sounds.
3. Stop the coil directly over this
spot on the ground.
4. Now move the coil straight
forward and straight back
towards you a couple of times.
5. Again make visual note of the
spot on the ground at which
the "beep" sounds.
6. If needed, "X" the target at
different angles to "zero in" on
the exact spot on the ground at
which the "beep" sounds.
When pinpointing a target, try drawing an "X",
as illustrated, over where the tone is induced.
COIL MOVEMENT
When swinging the coil, be
careful to keep it level with the
ground about one inch from the
surface. Never swing the coil like
a pendulum.
WRONG
CORRECT
TARGET DEPTH ESTIMATION
After verifying a desirable
target, pass the coil again, but
raise the coil 1" over the
ground, progressively higher
with each sweep. Note the coil
elevation at which the signal
disappears. With practice, you
will be able to approximate
target depth.
15