Assembly - Bounty Hunter Tracker II Owner's Manual

SSEMBLY
No tools are required.
Follow these steps:
Unpack your detector and find
1
the following parts:
•Control Housing, attached to
S-rod handle and searchcoil.
•Lower stem (short metal
tube with plastic extension
and silver bottom).
• (2) Coil knobs. One with a
shaft attached, one without.
Depress the button on the lower
2
stem and push the lower stem
into the upper stem.
Wind the searchcoil cable
3
around the two-piece stem.
Leave some slack in the cable
4
as you reach the end of the
lower stem.
Attach the coil to the stem using
5
the coil knobs.
Install two (2) 9-volt ALKALINE
6
batteries (not included).
There are two battery doors on
the back of the detector body.
4