Table of Contents
Advertisement
Chapter 4. Using the Configuration/Setup Utility
program
The Configuration/Setup utility program is stored in the electrically
erasable programmable read-only memory (EEPROM) of your computer.
You can use the Configuration/Setup utility program to view and change
the configuration settings of your computer, regardless of which operating
system you are using. However, the settings you select in your operating
system might override any similar settings in the Configuration/Setup
utility program.
Starting and using the Configuration/Setup Utility
program
The Configuration/Setup utility program is started automatically when
POST detects that hardware installed in your computer has resulted in a
downgraded configuration. A 162 POST message is displayed. See
"Power-on self-test (POST)" on page 98.
To start the Configuration/Setup utility program:
1. Turn on your computer. If your computer is already on when you start
this procedure, you must shut down the operating system, turn off the
computer, wait a few seconds until all in-use lights go off, and restart
the computer. (Do not use Ctrl+Alt+Del to restart the computer.)
2. When the Configuration/Setup utility prompt appears in the lower-left
corner of the screen during startup, press F1. (This prompt appears on
the screen for only a few seconds. You must press F1 quickly.)
3. If you have not set a password, the Configuration/Setup utility
program menu appears on the screen. If you have set a password, the
Configuration/Setup utility program menu will not appear until you
type your password and press Enter. See "Using passwords" on
page 46 for more information.
Note: If new system hardware has been added and one or more of the
following statements are true, the Configuration/Setup utility
program menu will display before control is passed to the
operating system.
Copyright IBM Corp. 2001
Enhanced POST is in effect.
Power-on password is enabled.
Administrator password is enabled.
43
Advertisement
Table of Contents
Troubleshooting
