Appendix Self-Test Page - Microcom 814M Operator's Manual

Appendix
Self-test Page
Print self-test page in the following steps:
•
Turn off the printer power.
•
Hold the feed button for at least one second while turning on the power.
The printer will start to print a self-test page. Take the 203 dpi, Serial + USB interface model as an example.
The self-test paper is shown as follows:
Boot Firmware
Main Firmware
H/W Parameters
Communication Interface
Resident Fonts
***MICROCOM814M-3 TEST FORM***
H/W ID
Flash Memory Size
Flash Logos Size
Resolution
Print Width (Max)
Fixed Left Margin
Fixed Right Margin
Print Speed (MAX)
Dark Scale
Cutter
Paper Roll Width
Presenter
Presenter Mode
Presenter Wait Time
Rx Buffer Size
Interface Type1
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Command CR
Data Receive Error
Interface Type2
Font0 (18x34)
Font1 (13x24)
Code Pages
:FV2.010
:FV2.050
:MICROCOM814-3(U) 1
:1M bytes
:64k bytes
:300×300DPI
:216mm
:2mm
:2mm
:75mm/s
:100
:Enabled
:216mm
:Enabled
:Keep Paper
:3s
:4K bytes
:RS232
:38400bps
:8
1
:NONE
:DTR/DSR
:Disabled
:Ignored
:USB_ORU
:English
:English
:437,850,852
:858,860,863
40