Presenter Parts Explanation; Paper Holder; Paper Holder Appearance; Paper Holder Module Explanation - Microcom 814M Operator's Manual

3.4.2 Presenter Parts Explanation

1. Paper loading sensor –Used to detect paper status.
2. Prsln Sensor (optional) –Used to detect whether paper is retracted.
Caution: Paper sensor may be ineffective if exposed to direct sunlight!

3.5 Paper Holder

3.5.1 Paper Holder Appearance

Figure 3-13 Vertical Paper Roll Holder Appearance
1. --Paper roll shaft
2. --Paper roll support
3. --Paper near end sensor
4. --Paper near end sensor inter-connective socket
5. --Paper roll locating block (each one on the left and right)

3.5.2 Paper Holder Module Explanation

1. Paper near end sensor
−
User may check paper status by sending inquiry command (refer to "command set" for details) to
the printer.
−
Users can adjust the position of paper near end sensor to control the amount of remaining paper
according to different paper roll diameters (see figure 3-12 and 3-13). To adjust the sensor, please
loosen the two retaining screws and move the positioning board up or along the slide track then
re-tighten the screws.
2. Paper roll shaft
−
Paper roll supports (2) are needed when a paper roll with a 50mm ID is used. For paper roll with
25mm ID, use only the paper roll shaft (1).
Figure 3-12 Horizontal Paper Roll Holder Appearance
14