Table of Contents
Advertisement
SE-2000 Configuration Utility
The Configuration Utility software allows a PC (running Windows XP Professional) to make changes to the mixer*.
A cable needs to be connected between the RS-232 port on the rear of the SE-2000 and the PC COM1 Serial
port.
This software Utility is free and can be downloaded from the following web page
http://www.datavideo.info/en/Mixer%20-%20Switchers/SE-2000
Once downloaded, run the install wizard and follow the on-screen prompts. The installation will leave an Icon on
the PC desktop as above. With the SE-2000 connected to the PC via an RS-232 cable, the initial utility screen will
be displayed as above, when the program is launched. Select the Logos tab to make the required changes.
Storing New Logos
The Configuration Utility software above allows a Windows XP Professional PC to make changes to the Logos
stored within the 14 memory slots of the SE-2000 mixer. This is done from the Logos tab shown below.
New Logos to LOAD and WRITE into these memory slots MUST be 256x192 pixels. Your new Logo needs to be
created in a graphics software package first as a TGA 32bit or BMP 24bit file with a clear Alpha Channel
background. The graphics software to create your Logo is not supplied by Datavideo.
21
Advertisement
Table of Contents
