Se-500 Rear Panel - Datavideo se-500 Instruction Manual

3.2

SE-500 Rear Panel

1a
1b
1. Video inputs, Channels 1, 2, 3, 4.
1a. S-Video (Y/C) input
1b. Composite video input (BNC)
2. Video outputs
2a. Composite video out (BNC)
2b. S-video (Y/C) out
2c. Component (Combine Composite &
Y/C with a breakout cable)*
2d. Quad preview output (BNC)
1. Video In (Channels 1, 2, 3, and 4 are all set up the same way)
a. Composite video input: takes a BNC connector from the composite output of a VCR, camera,
DVD player, etc.
b. S-Video (Y/C) input: takes a standard 4 pin S-video cable from the output of a VCR, camera,
DVD player, etc.
2. Video Output. These ports carry the Main video output of the SE-500.
a. Composite video out: BNC connector typically connected to a program monitor.
b. S-video out: standard 4 pin S-video (Y/C) connector, typically connected to a VCR, projector, or
monitor.
c. Y.U.V. video out: Combine Composite & Y/C with a breakout cable. These BNC connectors
carry the analog component Main video signal, and would typically be connected to a master
recorder (Betacam, DVCPro, or DVCam, for example), component video monitor, or a satellite
uplink. (See
d. Quad preview out: BNC connector carrying a quad video signal with effect, Tally light,
background, and speed indicators.
3. RS-232 control: for PC or other devices to remote control via RS-232
protocol. Please read the Appendix of
information.
2a
2c 2b
Video Sources for more information on connecting these ports to a device.)
3
2d
4
3. RS-232 Control
4. Tally Signal out
5. MIDI Control*
6. Microphone input Ch2 (1/4" jack)
7. Microphone input Ch1 (1/4" jack)
8. Audio inputs (Stereo, RCA connector)
9. Two Stereo Audio outputs (RCA)
10. Power switch
11. DC Power input 12V
RS-232 Protocol
14
8 9
5 6 7
for more
11
10