Specifications; General Information - Jøtul GF300 DV IPI Allagash Installation And Operation Instructions Manual

139495_Rev_C GF 300 DV IPI 9/11/12
GF 300 DV IPI

Specifications

Input Rates
Natural Gas
2 6,000 BTU/hr. maximum input
15,000 BTU/hr. minimum input
Propane
2 4,000 BTU/hr. maximum input
12,000 BTU/hr. minimum input
Inlet Pressure:
MIN
Natural Gas: 4.80 WC (1.24 kPa) 7.0 WC (1.74 kPa)
Propane: 12.0 WC (2.99 kPa) 14.0 WC (3.48 kPa)
Manifold Pressure:
MIN
Natural Gas: 1.2 WC (.30 kPa) 3.80 WC (.95 kPa)
Propane: 2.9 WC (.72 kPa) 11.0 WC (2.74 kPa)
• SIT Pro Flame 2 Intermitent Pilot Ignition - 120V / 60 Hz
• Steady State Efficiency: 70.5% NG / 72.3% LP
• AFUE Efficiency:
• CSA P4. 1-02 Fireplace Efficiency:
NG - 66.6% LP - 66.1%
• Factory Air Shutter Settings: NG - 1/8" LP - 3/16"
• Continuous Pilot Ignition Mode ( CPI) may also be used
• Power Requirement: 120 VAC, 4 amps for
IFC Module, optional Blower and Accent Lamp.
Back-up Battery Pack: 4, AA - 1.5V
• Remote Control Transmitter batteries: 3, AAA - 1.5V
• Ambient Temperature Range: 32 -122°F (0 - 50°C)
• Remote Radio Frequency: 315 MHz
C L
4
MAX
MAX
67.7% NG / 67.4% LP

General Information

THIS HEATER MUST BE INSTALLED AND MAINTAINED

BY A QUALIFIED SERVICE AGENCY.
The installation and repair of this appliance must be

done by a qualified service person. Failure to properly
install and maintain this heater could result in an
unsafe or hazardous installation, which may result in
a fire, explosion, property damage, personal injury or
loss of life.
This appliance should be inspected before use and

at least annually. More frequent cleaning may be
required due to excessive lint from carpeting, bedding
material, etc. It is imperative that control compart-
ments, burners, and circulating air passageways of
the appliance be kept clean. See Maintenance, page
26, for details.
THIS APPLIANCE MUST NOT BE CONNECTED TO A

CHIMNEY OR FLUE SERVING ANY OTHER APPLIANCE.
The installation must conform to local codes. Your lo-

cal Jøtul dealer can assist you in determining what is
required in your area for a safe and legal installation.
Some areas require a permit to install a gas burning
appliance. Always consult your local building inspec-
tor, or authority having jurisdiction, to determine
what regulations apply in your area.
CODE COMPLIANCE : Your local officials have final

authority in determining if a proposed installation is
acceptable. Any requirement that is requested by the
local authority having jurisdiction, that is not specifi-
cally addressed in this manual, defaults to local code.
In the absence of local codes, the installation re-
quirements must comply with the current edition of
National codes. In the U.S., these requirements are es-
tablished in the National Fuel Code, ANSI Z223.1.(NFPA
54) current edition. In Canada, the codes have been
established in CAN/CGA B149 Fuel Installation Code,
current edition..
C L
C L