Window Skirt And Side Doors Installation; Remote Control Handset Wall Holder Installation - Valor VENTANA 1200EAN Installation & Operating Instructions Manual

The fireplace comes equipped with a window skirt to
hide the underside of the firebox and two side steel
doors to hide the gas and electrical controls.
1. To install the window skirt, simply hook it to the
bottom frame of the window as indicated.
2. Sort the left hand side and the right hand side
doors—the tab to open the door should be towards
the outside at the bottom.
Take one door and locate the top hinge pin in the
holed bracket located inside the top front of the
outer firebox liner.
3. Slide the door up as much as possible and fit the
lower hinge pin in the bottom hole.
4. Repeat with the other door.
The doors should be maintained closed by a magnet
on each side of the window frame.

Remote Control Handset Wall Holder Installation

The remote control kit for this fireplace comes complete
with a wall-mounted holder. This holder is not required
in all installations but is provided as an optional feature
for those customers who wish to mount the remote
handset to the wall.
To install the holder to the wall, find a convenient
location and use the hardware provided with the kit.
See the diagram below for required hardware and
configurations. Note that the holder can be installed at
the base of a light switch plate.
Packing Contents:
1 Wall Bracket A
2 Screws B
1 Screw C
2 Wall Anchor D
1 Spacer E
(detach before assembly)
1 Wall Bracket F
32

Window Skirt and Side Doors Installation

Alternative 1
Tab at
bottom
IMPORTANT. The location of the remote control
handset is important to assure proper temperature
regulation. To obtain a constant temperature, we
recommend that the handset should be between 3
and 15 feet away from the appliance but not directly
above it. We also advise that the handset should
be located away from any other heat source and not
in direct sunlight as this may affect the temperature
sensor located in the remote handset.
Alternative 2
Alternative 3
Switch Plate