Valor VENTANA 1200EAN Installation & Operating Instructions Manual page 35

Batteries
BEFORE changing the batteries, turn off the valve using
the manual On/Off switch —see instructions below.
The appliance uses four 1.5 V AA batteries for its remote control
receiver and one 9 V battery for its handset. Batteries should
last one to two seasons, depending on usage. Removing the
batteries in the off-season will extend the battery life. Should the
batteries lose power, the control may be operated by manually
turning the control knob at the valve or by turning off the valve at
the switch.
To replace the batteries in the remote control receiver:
1. Open the side panel to the left of the window.
2. The receiver is located under the valve and it is retained to its
platform by a Velcro tab. Grab the receiver and pull it out from
it's platform.
3. Slide and remove the receiver cover.
4. Replace the 4 AA batteries.
5. Replace the cover.
6. Put the receiver back on its platform pushing it in so it
attaches to the Velcro tab. If it was unhooked, replace the
antenna in its clip.
IMPORTANT: The antenna MUST NOT TOUCH the ignition
wire to avoid a short-circuit.
Servicing
If any attention is required for your appliance, contact your
supplier quoting the model number. It will be helpful if the
appliance serial number can also be quoted. This number is on
the rating plate, which is located on the firebox left hand side
panel behind the valve assembly. Open the left hand side door
to see it. The replacement parts are shown at the end of this
manual. Please always quote the part number and description
when requesting spare parts.
Manual On/Off Switch
In cases where you want to turn off your fireplace and
cannot do it with the remote control handset (misplaced,
lost, dead batteries, etc.) or if you need to replace the
receiver's batteries, you can turn off the appliance with
the manual switch located on the right hand side of the
valve.
If the wall switch is installed and the remote control will
not be used, remove the battery from the handset and
store it away.
If you are planning not to use your fireplace for a
prolonged period of time, remove the battery from the
remote handset and turn off the gas valve using the
manual ON/OFF switch.
Owner's Information
Antenna
!
To avoid short-circuit to the
receiver, position the antenna so
that it DOES NOT TOUCH the
ignition wire.
ON
OFF
If the antenna was
unhooked when
replacing batteries,
hook it back to its
clip.
!
NOTE: It MUST
NOT TOUCH the
ignition wire!
Ignition Wire
35